TRANSPORT LIVE ROLLER
10.3-4 Contact Customer Care at 1.844.4HYTROL FLOOR SUPPORTS - MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. CONVEYING SPEED - Other constant and variable speeds. 17 FPM - 400 FPM. V-belt drive supplied under 17 FPM. Note: Capacity affected with speed change. HIGH PERFORMANCE UNDERSIDE CENTER DRIVE - Required on units over 100 ft. long. Maximum length: 200 ft. (used with 2 HP, 3 HP, or 5 HP motor and reducers). SIDE MOUNTED LOW ELEVATION CENTER DRIVE - Motor reducer unit mounted to side of conveyor. Minimum low elevation16 in. with old style and 18 in. with new style. V-BELT DRIVE - V-belt supplied between motor and reducer. Allow 65 in. O-RING DRIVE CHAIN - With sealed-in lubricant (recommended for applications that do not permit regular lubrication). GUARD RAILS - Adjustable Universal Channel Guard Rail. See Accessory section. Note: If product comes into contact with guard rails, product flow will be affected. Fixed channel overlapping one direction. PACKAGE STOP - Angle and raised roller end stops. POLY-TIER SUPPORTS - 36 in. to 120 in. support heights in 6 in. increments. Knee braces required. CEILING HANGER - 5/8 in. dia. x 8 ft. long unplated steel rods fully threaded. Other lengths and galvanized rods available. MOTOR - Energy efficient, single phase, other characteristics. 2 HP maximum. ELECTRICAL MOTOR CONTROLS - Non-reversing magnetic starters and push-button stations. AC variable frequency drive.