ACCUMULATION 24-VOLT

11.1-4 Contact Customer Care at 1.844.4HYTROL

EZLOGIC ACCUMULATION SYSTEM

Hytrol's EZLogic , or Electronic Zero-Pressure Logic Accumulation System, combines the sensing accuracy of photo-electronics with discrete electronic logic control without the use of a PLC or pneumatic logic components. The EZLogic Accumulation System provides many features including: Zero-Pressure Accumulation of Product Zone Stop function is built in. Any zone may be transformed into a workstation by connecting a dry contact switching device to the auxiliary port of the EZLogic Zone Controller. This feature is always used at the discharge end of the conveyor line, and may be used at any other location where a zone stop is required. Selectable Modes of Operation Singulation Mode - Product separates while traveling down the conveyor and when it is released from the conveyor, creating a zone-length gap between products. Enhanced Slug Mode w/ Jam Protection - Product does not separate when traveling down the conveyor or when it is released from the conveyor. This allows higher product throughput at any given conveyor speed. Product will not separate on the conveyor even when accumulation has been activated at the discharge end. Cascaded Slug Release - Rather than releasing all zones simultaneously, this function introduces a momentary delay in the release of each zone, from discharge upstream. Dynamic Zone Allocation - Automatically adjusts the conveyor's zone length to accommodate the length of the product being conveyed. Improves conveyor efficiency and system flexibility.

Optional Equipment

FLOOR SUPPORTS - MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. POWER SUPPLY (FOR MOTORS) - 120 to 240V, Single Phase, 20 and 40 Amp available. 120 volt at 4.56 Amps. POWER SUPPLY (FOR MOTORS) 460 volt, 3 Ph., 20 and 40 Amp available. MOTOR AND SEPARATE CONTROL CARD - Available with 3 Amp settings. POLY-TIER SUPPORTS - 36 in. to 120 in. support heights in 6 in. increments. Knee braces required. CEILING HANGER - 5/8 in. dia. x 8 ft. long unplated steel rods fully threaded. Other lengths and galvanized rods available. HIGH-SPEED DRIVE SPOOL - Provides a speed range of 50 to 200 FPM. EZLOGIC - See EZLogic Components Page.

190-E24EZ