12.5-10 Contact Customer Care at 1.844.4HYTROL

DIVERTERS & CONVERGERS ACCESSORIES

E24 DOUBLE POWERED PIVOT DIVERTER

CAPACITY - 75 lbs. maximum package weight. PACKAGE SIZE - Minimum 4 in. wide x 6 in. long, maximum 26 in. wide x 36 in. long. Small packages must not be top heavy. Product must be justified to divert side. DIVERTER SPEED - 50 to 200 FPM set on motor controller. DIVERTER MECHANISM - Two rows of 3 1/8 in. dia. wheels with urethane treads driven by 3/8 in. dia. urethane belts. MOUNTING - Bolts to 190-E24 15 in. to 39 in. BR, RH or LH diversion 30 degree spur discharge (spur not included). Minimum elevation: 14 in. Note: O-rings must be opposite discharge side. Widths over 39 in. BR contact factory. CYCLES - Up to 40 times per minute. MOTOR - 24VDC motor, 3 Amps per motor, one each divert bank. MOTOR CONTROLLER - Controls and protects motor, one each divert bank. AIR CYLINDER - 1 1/4 in. dia. bore x 2 in. stroke, double acting with internal rubber bumpers both ends. AIR VALVE - Single solenoid 4-way valve with speed controls, 1/8 in. NPT valve ports. Requires maintained electrical signal of 24VDC watt from photo cell, limit switch, etc. (not supplied). Diverter will stay in diverted position until signal is broken. Current consumption is .32 Amps holding. AIR REQUIREMENTS - Minimum pressure 60 PSI; Maximum 125 PSI. Free air consumption at 60 PSI, .064 cu. ft. per cycle. Note: To eliminate contaminants in air supply line, a filter-regulator should be installed prior to the air valve (not supplied as standard). The Double Powered Pivot Diverter is designed for use with models 190-E24 and 190-E24EZ accumulating conveyor. Products are automatically diverted onto adjacent 30-degree spur lines.

MIN. TO DISCHARGE END OF SECTION 7-1/2" 6 MIN. TO INFEED END OF SECTION 7-1/2"

RH Spur LH Spur RH Diverter LH Diverter

Standard Specifications