HSS

TRANSPORT HEAVY-DUTY BELT-OVER

3.1-2 Contact Customer Care at 1.844.4HYTROL

Optional Equipment Standard Specifications

BELT - Belting available per customer specification. BED - 3 1/2 in. deep 10 ga. or 12 ga. formed steel slider bed. CENTER DRIVE - Minimum elevation 14 1/2 in. DRIVE PULLEY -8 5/8 in. diameter lagged pulley with through shaft design. TAKE-UP ROLLER - 4 in. diameter ROL-07S. SNUB IDLER - 2 3/4 in. diameter ROL-02. TAIL PULLEY - 4 in. diameter ROL-07S. DRIVE BEARINGS - Sealed, pre-lubricated, self-aligning, cast-iron spherical ball bearing. MOTOR - Available from 3 to 15 HP. BELT SPEED - Available from 250 to 600 FPM. CAPACITY - 35 lbs. per linear foot. Do not exceed capacity in chart below. FLOOR SUPPORTS - Available with a wide range of adjustment. Specify top of belt elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee bracing not included. BELT - Option per customer specifics. UNDERSIDE BED COVERS - Hinged expanded metal per customer specifics. NOSEOVER - Single noseover for transition from angled to horizontal position. TAIL ROLLER - 4 in. diameter ROL-07SX (Spherical Roller Bearings). BED - Available in 6 5/8 in. deep (12 ga.). CABLE RAIL ASSEMBLY - For mounting cable. MOTOR - 2, 3, 5, 7 1/2, 10, and 15 HP available. SIDE GUARDS/PAN - Available in 2 in. to 36 in. high (2 in. increments). SLAVE TAKE-UP - Available in all widths, for scanning applications. HP Selection Chart Length Speed (FPM) 15' 25' 50' 75' 110' 250 2 3 5 300 2 3 5 7.5 350 2 5 7.5 450 3 5 7.5 10 540 3 5 7.5 15 Note: HP calculations based on 6000 PPH. For higher rate, contact factory.