TRANSPORT MODULAR BELT

4.3-2 Contact Customer Care at 1.844.4HYTROL FLOOR SUPPORTS - MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. BED - Stainless steel in lieu of powder-painted HRS (excluding aluminum support bars). BELT - Other belts available, contact factory. BELT SPEED - Other constant and variable speeds. V-belt drive supplied on speeds under 15 FPM and with variable speeds. Note: Capacity affected with speed change. V-BELT DRIVE - V-belt supplied between motor and reducer. Allow 65 in. O-RING DRIVE CHAIN - With sealed-in lubricant (recommended for applications that do not permit regular lubrication). CEILING HANGER - 5/8 in. dia. x 8 ft. long unplated rods fully threaded. Other lengths and galvanized rods available. NOSEOVER AND NOSEUNDER - Can be incorporated to provide continuous belt travel from horizontal to incline or decline. MOTOR - Energy efficient, single phase, brakemotor, other characteristics. 2 HP maximum. ELECTRICAL CONTROLS - One direction magnetic starters and push-button stations. AC Variable Frequency Drive. END DRIVE - Located on discharge end of conveyor. Chain guard located on left hand side. BELT - Polypropylene 2 in. pitch flush grid, nominal 1 in. less than BR. BED - UHMW on aluminum slider bars, mounted to frame spacers. Mounted in 7 1/2 in. x 12 ga. powder-painted, formed steel channel frame bolted together with butt couplings. CROSS BRACING - Rods with turnbuckles are fastened to underside of bed to provide proper alignment of bed rollers and ensure tracking. One supplied in first 50 ft. of bed section lengths and one per 50 ft. of bed section length thereafter. Supplied in approximate center of lengths. DRIVE AND TAIL SPROCKETS - 10 tooth 6.4 in. pitch dia. molded plastic sprockets on 1 1/2 in. sq. shaft, 1 3/16 in. dia. shaft at bearings. SNUB ROLLERS - Located at drive and tail ends. RETURN BARS - UHMW on aluminum. BEARINGS - Sealed, pre-lubricated, self-aligning ball bearings on drive and tail shafts. SPEED REDUCTION - Sealed worm gear C-face speed reducer. No. 50 roller chain to drive sprocket. MOTOR - 1/2 HP, 208/230/460/575V, 3 Ph. 60 Hz. Totally enclosed C-face. BELT SPEED - Constant 65 FPM. CAPACITY - Maximum load per linear foot of conveyor 200 lbs. NOT TO EXCEED capacity in chart.

Standard Specifications Optional Equipment

PSB

Previous Page
Next Page