TRANSPORT MODULAR BELT
4.5-2 Contact Customer Care at 1.844.4HYTROL
SINGLE OUTPUT DISCONNECT PANEL DUAL OUTPUT DISCONNECT PANEL (MUST BE LOCATED AT THE CENTER OF CONVEYOR) ZONE GEARMOTOR INFEED EYE EZLOGIC ZONE CONTROLLER INFEED EYE EZLOGIC ZONE CONTROLLER EZDRIVE ZONE STARTER BOX EZDRIVE ZONE STARTER BOX IOP
Note: Infeed Wake-Up Eye used only on terminating infeed end of conveyor. Not used when connecting to upstream EZLogic conveyor through power supply isolation cable. BELT - 1in. pitch polypropylene plastic belt. BED - 1/4 in. UHMW over steel bed channels mounted in 7 1/2 in. x 7 ga. powder-painted formed steel channels. EZDRIVE SYSTEM - Shaft mounted gearmotor located at discharge of each zone. 1/2 HP, 3 PH, 60 Hz. Totally enclosed; fan cooled. 230 or 460 V (specify voltage). Includes EZDrive Disconnect Panel. Power is distributed zone-to-zone through pluggable cordsets. Power is connected from the starter box to the motor via SO type cord. Please contact factory if local code requires other than the standard power distribution techniques described. ACCUMULATION ZONES - 30 in. to 120 in. on 6 in. increments. EZLOGIC ZONE CONTROLLER - Located in each zone (retro-reflective). NEMA 1, 2, IP 62. UL Approved. IOP - Provides 27VDC, 100 watt power for EZLogic accumulation system; contains slots for 4 input/output boards. Should be located near disconnect panel. See chart for maximum quantity of zones. Requires 120VAC or 230VAC single phase input. CONVEYING SPEED - Constant 34 FPM. CAPACITY - See Chart. FLOOR SUPPORTS - Supplied as optional equipment. FLOOR SUPPORTS - HS Type floor supports are available with a wide range of adjustment. Specify top of belt elevation. One support required at every bed joint and ends of conveyor (for standard lengths and capacity). Holes in feet for lagging to floor. Knee braces recommended above HS-6 support. CONVEYING SPEED - Other constant and variable speeds available, contact factory. GEARMOTOR - 3/4 HP, 1 HP, and 1 1/2 HP available. EZDRIVE SYSTEM - Variable Frequency Drive for adjusting conveying speed or adjusting acceleration and deceleration time. EZLOGIC - See EZLogic Components Page.
Standard Specifications Optional EquipmentPrevious Page