PORTABLES
5.1-4 Contact Customer Care at 1.844.4HYTROL FLOOR SUPPORTS - MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-3 support. BELT - 1/2 in. x 1 in. galvanized flat wire mesh belt with 1 1/4 in. high steel angle cleats, spaced every 12 in. Galvanized low carbon steel or stainless steel. 1 in. x 1 in. or 1/2 in. x 1/2 in. mesh available. BELT SPEED - Other constant and variable speeds. V-belt drive supplied under 17 FPM. Note: Capacity affected with speed change. OVERHEAD END DRIVE - Higher than standard clearance above belt, specify. UNDERSIDE END DRIVE - Motor reducer unit mounted underneath bed. Extends down 11 in. from bottom of bed. PULLEYS - 6 in. tail with 1 3/16 in. dia. shaft at bearings or 8 in. drive with 1 3/16 in. dia. shaft at bearings. V-BELT DRIVE - V-belt supplied between motor and reducer. Minimum overall drive width 14 in. O-RING DRIVE CHAIN - With sealed-in lubricant (recommended for applications that do not permit regular lubrication). HIGHER SIDE GUARDS - 6 in., 9 in., or 12 in. high vertical sides in place of standard 3 1/2 in. high. Note: 12 in. high sides require higher than standard overhead or underside drive. LOW-POWERED FEEDER - Chain type driven from tail pulley of conveyor. Black friction surface belt. Includes MS-6 support. Note: Conveyor tail pulley is used for belt take-up. When belt tension is adjusted, feeder will have to be moved along with the take-up. Capacity affected with this option. MOTOR - Energy efficient, single phase, brakemotor, other characteristics. 2 HP maximum. ELECTRICAL CONTROLS - One direction manual start switch. Non-reversing magnetic starters. Push button stations. AC variable frequency drive.
Optional Equipment
PC
Previous Page